Vibration motor is installed correctly

When installation should pay attention to the following items:

1, winding insulation, such as be affected with damp be affected with damp should adopt corresponding method processing 500 v check winding insulation resistance by megger are, when close to the working temperature (70 ℃), shall be not less than 0.38 ohms, otherwise should be drying process.

2, the cables are in good condition, such as fracturing damage should be replaced in a timely manner.

3, the body is in good condition, if any damage, please contact us to change.

Vibration motor is installed on the vibration machinery, vibration motor of anchor bolt fastening, must each must add elastic washer under the nut.

Vibration motor early operation, due to the running-in between the bolt, nut and base plane, can reduce the fastening force, a little loose, so the early operation should be the motor of the anchor bolt screw for many times, at the beginning of the fastening once a day, two weeks after check tighten once a week.

Installed in place, on the basis of the body and all have the cable clamp device, are natural suspension cables between them, the total length with 300-500 - mm advisable, natural drape of curved radius of linear vibration device reference two vibrating motors working at the same time, should check whether the two vibrating motors to the contrary. Otherwise should change a motor power phase sequence, make two vibrating motors turned to the contrary, to guarantee the uniform material.